first try: blinking 4 colour monitor, no pi

Here is all the tutorials, FAQ and support for RaspiBoy Kit
Post Reply
herocks
Posts: 1
Joined: Sat 2 Sep 2017 12:13

first try: blinking 4 colour monitor, no pi

Post by herocks »

Bonjour le monde,

I have followed the online tutorial to set-up the pi zero (I have 1.3) and put together the raspiboy.

The power LEDs light up, but when I turn the unit on all I get is a screen that slowly blinks black, white, red, green, blue over and over. I open up the unit and made sure all the connections were as they should be; nothing seemed out of place, even after rewatching the tutorial video again.

I will be getting a mini HDMI cable so that I can check whether the pi zero is properly configured, but I was wondering if anyone else has had this issue. Any ideas on what could be going wrong?

Any advice would be appreciated.

Un gros merci pour le superb kit! J'espère bien pouvoir m'en servir d'ici peu.

p.s. My grey right rear button came with one of its little pins broken. Not a big deal since I could use the black button instead, but would have been nice to have the choice to have either black or grey buttons.
Post Reply