Charging problem ?? (VERY HOT + two last leds + no boot when charging...)
Posted: Sat 31 Mar 2018 22:54
Hi there !
Nice to meet you (first of all... ^^" ).
I'm here because I've a problem. I've bought a raspiboy kit 6000 mAh, and i've some issue.
I've connected it to a usb charger, and fastly i've a lot of heat right uppster the left trigger.... I've disassembled it and it appears that the heat sing at the bottom of the 8bitcraft PCB is overheating. So I've done some research. My voltage on the charger is ok (4.75v) and my 8BitCraft PCB is a 1.3 version.
Plus: my console doesn't boot even if it's charging (it's said on the website->store->pcb item page that it CAN boot up if it's charging at the same time), it smell litterally the hot electronics and it's always with the two last leds ON. No switch between the One Led Mode and the Two Led Mode.
Is my PCB dead? after only 24 hours???
Hope not... If anyone can answer me, thanks by advance.
Yamiikage (France)
Nice to meet you (first of all... ^^" ).
I'm here because I've a problem. I've bought a raspiboy kit 6000 mAh, and i've some issue.
I've connected it to a usb charger, and fastly i've a lot of heat right uppster the left trigger.... I've disassembled it and it appears that the heat sing at the bottom of the 8bitcraft PCB is overheating. So I've done some research. My voltage on the charger is ok (4.75v) and my 8BitCraft PCB is a 1.3 version.
Plus: my console doesn't boot even if it's charging (it's said on the website->store->pcb item page that it CAN boot up if it's charging at the same time), it smell litterally the hot electronics and it's always with the two last leds ON. No switch between the One Led Mode and the Two Led Mode.
Is my PCB dead? after only 24 hours???
Hope not... If anyone can answer me, thanks by advance.
Yamiikage (France)