8BCraft Forum

Good afternoon, I already received my raspiboy and I'm having sound problems
I followed the tutorial correctly and modified the txt file and it still does not work.
what am I doing wrong?

I too am having issues, I have sound but very faint, and there is a lot of static coming through the speaker. I have followed the tutorial for the sound issues, this got me sound but its as stated before.

Do you have no sound at all or little?
If sound is not loud enought there's a setting in retropie to increase the volume.

If no sound at all do you have when you plug headphones? The sound goes like this :
RPI zero -> headphones -> amplifier -> speaker

If you have no voice at all it's likely config.txt problem.
If you have sound in the headphone but nothing on the speaker then it's likely that the amplifier IC got damaged with electrostatic discharge.

If problem don't solve you can send me an email at hello@8bcraft.com

In my case, there is no sound at all, could you upload the txt file you have in your configuration?
thank you very much

Have a look here :
https://www.8bcraft.com/assembly-tutorial/

Admin wrote:Do you have no sound at all or little?
If sound is not loud enough there's a setting in retropie to increase the volume.

I will try this, at first it was very bad sound with static. I re-created the retropie image and fixed the sound problem but its still low.

Admin wrote:If no sound at all do you have when you plug headphones? The sound goes like this :
RPI zero -> headphones -> amplifier -> speaker

have not tried headphones yet.

Admin wrote:If you have no voice at all it's likely config.txt problem.

not an issue

Admin wrote:If you have sound in the headphone but nothing on the speaker then it's likely that the amplifier IC got damaged with electrostatic discharge.

not an issue

Admin wrote:If problem doesn't solve you can send me an email at hello@8bcraft.com

will do if i need the assistance thanks!

Admin wrote:Have a look here :
https://www.8bcraft.com/assembly-tutorial/

I follow the tutorial correctly and I still have no sound