Headphone sound only on left channel

Here is all the tutorials, FAQ and support for RetroStone
torofinance
Posts: 28
Joined: Thu 20 Sep 2018 14:24

Headphone sound only on left channel

Post by torofinance »

"Headphone sound only on left channel"

I have tried 2 Apple Earpods (with 3.5mm) so I do not think the "quality" is the issue.

I have opened up my retrostone, the "volume problem" seems to have been fixed at the factory already, however maybe they have applied not enough tin? (Photos attached)

Image

Image
User avatar
Admin
Administrateur du site
Posts: 505
Joined: Sat 10 Dec 2016 13:12

Re: Headphone sound only on left channel

Post by Admin »

Hmm that seems correct.
Maybe the headphone connector is not soldered correctly. Can you send me pictures of the headphone connector?

I got a unit back with this problem.
torofinance
Posts: 28
Joined: Thu 20 Sep 2018 14:24

Re: Headphone sound only on left channel

Post by torofinance »

Looks like this:

Image

Image
niceHair
Posts: 1
Joined: Tue 16 Oct 2018 23:37

Re: Headphone sound only on left channel

Post by niceHair »

Try using (or borrowing) another pair of earphones that do not have controls built into the cord itself.

I encountered similar issues when using my Apple earphones (an iPhone accessory) with RetroStone. I believe the volume/function comtrol located on the cord that feeds the right-hand earpiece was weakening the audio signal. I swapped it for a pair of cheap Sony earphones and got good sound through both channels.

I hope you can try this and that it works for you.
User avatar
Admin
Administrateur du site
Posts: 505
Joined: Sat 10 Dec 2016 13:12

Re: Headphone sound only on left channel

Post by Admin »

niceHair is probably right, it can be the earphone that has a special audio jack that is not compatible with this basic one.

Can you test with other headphones and let us know if that fix the problem?
torofinance
Posts: 28
Joined: Thu 20 Sep 2018 14:24

Re: Headphone sound only on left channel

Post by torofinance »

I was hoping your reply was the problem, does not seem likely...

Tried with these (beats pro, no microphone)
-> when fully inserted they only play on the right, when i wiggle them out a little they only play on the left
Image

I also tried with these (apple headphones, no microphone)
-> when fully inserted i hear sound on both channels, but extremly low, even when fully jacked up the volume i hear is very very low (but right and left yes)
Then i wiggle them out a little - same result as with the expensive beat-pro headphone.

Would putting more solder (tin) on help?

Image
User avatar
Admin
Administrateur du site
Posts: 505
Joined: Sat 10 Dec 2016 13:12

Re: Headphone sound only on left channel

Post by Admin »

Sorry for late reply,
I checked a bit and I think it's your left channel that does not reach the headphones.
Tried with these (beats pro, no microphone)
-> when fully inserted they only play on the right, when i wiggle them out a little they only play on the left
I have headphones with same connector as the one in your picture, so it should work. You have sound on left when you wiggle them out a little because the L connector of your headphone touch the R channel when you wriggle it out.

So the problem can come from several places. I think it's probably one solder that is wrong on the left channel.

Image

By chance do you have a multimeter to check continuity of the L channel? If no can you visually check the L pin on the wheel if it is soldered correctly ? The "L pin" on the connector seem to be soldered correctly.

Also I checked your solder picture again. It might be the R82 solder that is not correct. Because it makes a ball. Maybe it means that it is not touching both pads of the resistor correctly. Can you try resoldering it ? Check closely if the solder touch both pads.
User avatar
Admin
Administrateur du site
Posts: 505
Joined: Sat 10 Dec 2016 13:12

Re: Headphone sound only on left channel

Post by Admin »

Yes I think the R82 solder could be a "cold joint" as described on this picture:
Image

This means the solder is not sticking to the pad, just very close. This can happen if the pad is not hot when the solder is applied.
suaviant
Posts: 11
Joined: Sun 19 Aug 2018 16:27

Re: Headphone sound only on left channel

Post by suaviant »

+1 to earphones with remotes not working.

It's to do with some standard. Xperia Play has the exact same problem. If I remember there is an adapter you can get that might fix the problem.

Edit:
The standards are CTIA and OMTP. OMTP seems to be more standard. I have ordered a converter and will test it out when it arrives in a couple of weeks. Until then using mic/remote-less earphones works.
Aggdaddy
Posts: 10
Joined: Thu 3 Jan 2019 18:55

Re: Headphone sound only on left channel

Post by Aggdaddy »

I decided to do a little gaming with the retrostone today but with headphones. Both of my headphones use a mic, so they use four sections on the 3.5mm headphone connector. I get stereo sound during bootup and while in the menu when the music is playing.

However, when I play a game, the sound could be low, or non-existent or even coming out of speaker instead of my headphones. I thought it was software related, but if I back out my headphones of the jack about 1mm, I get sound in both ears. Not sure if it's stereo, but it's better than when the connector is fully inserted.

If everybody is having this issue, might be best to put this in the description that the use of wired headphones with mics aren't fully compatible with this device.
RSpic4.jpg
RSpic4.jpg (147.28 KiB) Viewed 9097 times
Post Reply